I had configured my wrt54g as an access point and disabled dhcp. now i want to re enable dhcp and use it as a main router but unable to access the setup utility for the router. Any suggestions on how i can enable dhcp again?
I had configured my wrt54g as an access point and disabled dhcp. now i want to re enable dhcp and use it as a main router but unable to access the setup utility for the router. Any suggestions on how i can enable dhcp again?
1.
You can reset the router and start all over again.
2.
If you are getting connected to Internet and surf
get your Dynamic IP
Current IP Check
3. In browser type above Ip[ address.
4. A window will open asking you for Modem/router Id and PW.
5. Access the modem and reset settings.
6. Which is the adsl modem you are using ?
( presume WRT54Gis not "3 in one ")
7. START Select RUN type cmd OK
New window opens
type ipconfig /all
Default gateway is modem's or router's.
REF:Linksys WRT54G User Guide
Feedback.
Last edited by essbebe; 09-19-09 at 11:09 PM.
There are currently 1 users browsing this thread. (0 members and 1 guests)