Thread: PPPoe settings

I am in the dialup mode.every time i am using to dialing up the connection to browse. .Please tell me the process to change it into the PPPoe method . I am using WA3002G4 modem . 2)Where can i get information on this?

The link below describes WA3002-g1 touter:

WA3002-g1 (Type-II) ADSL MODEM MULTIUSER CONFIGURATION

You modem will have a different setup page but concepts are same. Use the same values.

Originally Posted by just4kix

The link below describes WA3002-g1 touter:

WA3002-g1 (Type-II) ADSL MODEM MULTIUSER CONFIGURATION

You modem will have a different setup page but concepts are same. Use the same values.

Please tell me the settings for My modem's model only. Why because if any problem faced ,no one from the exchange respond's.
2) If any error done during the modification or changes done unfortunatly.What should we do?Can i click on 'default settings ".Where is that option available in the DSL routor's page of mine?Once i found that .

Visit this page for most common BSNL routers. Not all routers may be listed but the procedures are more or less same.

BSNL BROADBAND MAIN MENU

1. When this page opens, click on the modem/router of your choice.
2. For PPPoE, click on the link "ADSL Modem Configuration for Multiuse".

ashok try this , it will work


UT300 MODEM HAVING DSL LAMP / WA 3002 G4

Open browser (E.g. Internet Explorer, Opera , Firefox)
Type 192.168.1.1 in Address bar. click GO
Enter both Username and Password as admin
Click OK
click advanced setup
click edit at the right end of the line having 0/35 as VPI/VCI value
click Next
select bridging and click next
click Next
click Next again
click save
click save/reboot
wait till reboot complete (3 minutes),Now follow step-2

Originally Posted by Alexina

ashok try this , it will work


UT300 MODEM HAVING DSL LAMP / WA 3002 G4

Open browser (E.g. Internet Explorer, Opera , Firefox)
Type 192.168.1.1 in Address bar. click GO
Enter both Username and Password as admin
Click OK
click advanced setup
click edit at the right end of the line having 0/35 as VPI/VCI value
click Next
select bridging and click next
click Next
click Next again
click save
click save/reboot
wait till reboot complete (3 minutes),Now follow step-2

Thank for providing the Info.But i asked the settings to change Dial up mode to PPPoE.

well.. i think there can only be one of them.. Either u can DIAL connection which is required when modem is set in BRIDGE mode.. and the other way is to connect directly which requires modem in PPPoE mode...

i tried ur process but its not workin firefox,opera both give step by step process or somthing to change my primery password and user name of modem other will fail to pay my big bills.









:surrender:help less