Thread: LAN status no connectivity or Limited.

hi,
router model UT300R2U
XP (sp-2)
LAN - 10/100 integrated with M.B

the problem is LaN shows status "no connectivity or limited connection"
(start--> connect to ---> network connections --->LAN properties ---->General--->Internet protocol(tcp/ip)properties )

Under internet protocol properties ---- ther is no ip address i feel tis might be the problem

but ter is no problem with internet connection, a exclamation mark appears on LAN tray icon, how to fix tis problem.

Thanks!!

if it is telling you there is limited or no connectivity then please check your IP address from command propt for that you can use command ipconfig

after this you can simple go ahead and try to release and renew IP Address
To Release IP Address

ipconfig/release

it will provide you output as IP address 0.0.0.0
after this renew IP Address

ipconfig/renew

that should help you in this
and you can go to control panel>>network connections>>LAN>>properties then untick the option which reads Notify me whenever this connection have limited or no connectivity

try this and please update

or you can go to control panel->network connection->local area connection properties->tcp/ipv4 properties-> enter ip address as 192.168.1.10 and gateway as 192.168.1.1 .. and then try...

I think you have assign the Ip address, mannually as Superprash 2003 said

Originally Posted by smoothvibes

if it is telling you there is limited or no connectivity then please check your IP address from command propt for that you can use command ipconfig

after this you can simple go ahead and try to release and renew IP Address
To Release IP Address

it will provide you output as IP address 0.0.0.0
after this renew IP Address


that should help you in this
and you can go to control panel>>network connections>>LAN>>properties then untick the option which reads Notify me whenever this connection have limited or no connectivity

try this and please update

not ableto run ipconfig, after typing ipconfig the dos screen appears and remains only for fraction of seconds. :48:

Originally Posted by superprash2003

or you can go to control panel->network connection->local area connection properties->tcp/ipv4 properties-> enter ip address as 192.168.1.10 and gateway as 192.168.1.1 .. and then try...

it worked , wat to type in at subnetmask

Also i m not able to look at router settings by using 192.168.1.1 (router model UT300R2U) i have upgraded my system recently, i was able to do so on my older machine.

Originally Posted by bingbang

it worked , wat to type in at subnetmask

255.255.255.0

Originally Posted by bingbang

not ableto run ipconfig, after typing ipconfig the dos screen appears and remains only for fraction of seconds. :48:

1. Go to Start --> Run.
2. Type 'cmd' in the run window and hit ENTER
3. A DOS window will open.
4. In this window, type ipconfig/all and hit ENTER
5. Paste the results.

Originally Posted by iChaitanya

255.255.255.0

Originally Posted by just4kix

1. Go to Start --> Run.
2. Type 'cmd' in the run window and hit ENTER
3. A DOS window will open.
4. In this window, type ipconfig/all and hit ENTER
5. Paste the results.

thank u

How to change router settings not able to open with default address 192.168.1.1

have you assigned manual ip to your pc?? as posted by justkix , type ipconfig and post output here.. also type in the same window ping 192.168.1.1 and post output

ping 192.168.1.1 gives the result Request timed out

ipconfig output?

Thanks! for u all smoothvibes, superprash, just4kix, ichaitanya, robert 007 for u r efforts in suggesting the solution.
i fixed the problem by assigning defaultgate way with the address of router, once again , THANKS to u all folks