Thread: fails to acess the 192.168.1.1

Hello guys

I have a modem of ut300r2u but i am not able to open the site 192.168.1.1.if you have any knowledge regarding this then i request to you pls help me.


thanks & regards.
rajneesh sharma

i am too facing the same prob, i wanted to port forward but i am too not able to access 192.168.1.1

Start > run > cmd > ipconfig/all and check that your gateway is 192.168.1.1

If not change it or try to use the default gateway IP as shown in the cmd.

hxxp://mumbai.mtnl.net.in/triband/htm/utstarusrguide1.0.pdf

it is assumed that internet is working
for Option 3
and you cannot
access the Modem settings.

REF:New Page 1

Option 1 ;
Start Network LAn properties
TCP/IP properties
Check what is the default gateway.
Say 192.168.1.1. this is modem's address.
For utstar ID admin password utstar.

if not successful

Option 2 :
In above select Obtain Ip address automatically.
Save Apply
Again check Ip 192.168.1.x
subnet 255.255.255.0
default gateway 192.168 .x.x
try this again
Still No success

Option 3 : NEW

Check your present dynamic Ip here.
What is my IP address? IP Address Tracer, Internet Speed Test, DNS Tools

Then type it in IE browser address bar
http://111.222.33.44 ( Imaginary IP)
A window should open asking for modem ID and PW !





If still no go

Option 4 ;

Reset the modem with power on for 20 / 30 seconds
Set to factory settings.
Now try 192.168.1.1

( hope you have also, downloaded the user manual 37 pages PDF mentioned above for checking your entries !)

Option 5 :
Give feedback +ve or -ve

i knew option 4, but i wanted any other way to access 192.168.1.1 but none of them worked

post output of ipconfig from the command prompt