Thread: Wifi Connectivity Problem

Hi guys..


i have upgraded from my type1 modem to type4 with UTStarcom wa3002g4 modem, i have purchased belkin network wifi card for connectivity. drivers are fine at the both ends. i am facing frequent disconnection of wifi though connectivity with Ethernet port are fine. i scrolled down all the posts and haven't found any answer yet. please help me..


Thanks
Prasanth

Book mark this link.
http://www.indiabroadband.net/bsnl-b...reference.html (UTSTAR WA3002-G4 quick reference)

1.Change Mod mode to GDMT
2. In Wireless settings select ch 6 or 11.

3.Keep the WIfi Utstar at a higher height.
4. Presume signal strength is " excellent " in Belkins

5. Change DNS to 208.67.220.220 and 208.67.222.222

.

hi essbebe ..


Thanks for your quick reply i am unable to get "Excellent" signal status, since the modem was placed in the ground floor and i am accessing in the first. i managed to get off modem a little higher ground from the cpu since i am using Ethernet port on the same. the below is my configuration. shall i change the DNS as well as uncheck the other options other than G.Dmt ??


Regards
Prasanth

Uncheck ADSL2+ only
but keep GDMT Glite and t413
also adsl2 bitswap enabled. rest oK.

compare snr attn data everytime you change above.
if you keep only gmt sometimes you may not get connected.

Even 2 or three bars in Signal
strength in wifi router enough for stable connection.

As wireless waves are "Line of Sight" propagation,
experiment with height, location for better signal.

Para two:
If possible position position Modem and desktop in FF.
Check any phone junction is available. or
take an extension ( rj11 twin wire can be used ).
Use adsl splitter also. there.
Wifi range should improve.