Thread: Not access to the internet

i would like to configure dlink dir-300 router with huawei mt882 modem for bsnl broadband for wireless networking. give me full tech support for this. is there is need to upgrade router firmware, i have f.ver 1.03 of router.

You dont need to upgrade the router firmware.

First setup your mt882 to bridge mode. VPI= 0 VCI= 35
After seting the Bridge mode connect mt882 Lan port to dir-300 WAN port
The connection cable should be CAT-5 straight through cable with RJ45 connector.
I think you have this cable. This cable use when you connect your Computers lan port to Router mt882 lanport or dir-300 lan port.
Now connect your computer lanport to dir-300 lan port. and browse the GUI web pages.
the address is http://192.168.0.1 or http://192.168.1.1

To manually set up the Internet connection, click the Manual Internet Connection Setup button on the Router’s opening window.
Choose PPPoE

Enter your PPPoE user name.

Enter your PPPoE password and then retype the password in
the next box.

Enter the ISP Service Name (optional).

Enter the IP address (Static PPPoE only). You dont need this.

Enter the Primary and Secondary DNS Server Addresses IF you need.

Enter a maximum idle time during which the Internet connection
is maintained during inactivity. To disable this feature,
enable Auto-reconnect.

Maximum Transmission Unit - You may need to change the
MTU for optimal performance with your specific ISP. 1492 is
the default MTU.

Select either Always-on, Manual, or Connect-on demand.

i contact the customer care of dlink they help me but in different manner. they connect lan port of modem to lan port to router (act as switch) as below...
Dlink replies.............
Connect the PC directly to the LAN port of the router DIR-300.

Windows XP:
Assign Static IP Address:
---------------------------------------
1 Click on Start > Control Panel > Network and Internet Connections > Network connections.
2 Right-click on the Local Area Connection which represents your network card and select Properties.
3 Highlight Internet Protocol (TCP/IP) and click Properties.
4 Enter your IP information for your network.
IP Address : 192.168.0.101
Subnet Mask : 255.255.255.0
Default Gateway: 192.168.0.1
5 Click OK. Click Close.


Open internet explorer and type 192.168.0.1 in the address bar. Press enter. Type admin as the username and leave the password blank. Click on Login..........Success.

Click on setup >> LAN Setup >> Disable the DHCP.

Change the router's IP address to 192.168.1.50.

Click on save settings.

Connect the BSNL modem to the LAN port of the DIR-300.

Windows XP:
Assign Static IP Address:
---------------------------------------
1 Click on Start > Control Panel > Network and Internet Connections > Network connections.
2 Right-click on the Local Area Connection which represents your network card and select Properties.
3 Highlight Internet Protocol (TCP/IP) and click Properties.
4 Enter your IP information for your network.
IP Address : 192.168.1.101
Subnet Mask : 255.255.255.0
Default Gateway: 192.168.1.1
Prefered DNS : as provided by ISP
Alternate DNS : as provided by ISP
5 Click OK. Click Close.

Try to access internet.........Success.

Originally Posted by kushwaha_vishnu

i contact the customer care of dlink they help me but in different manner. they connect lan port of modem to lan port to router (act as switch) as below...

Not possible. Lan port of router mt882 to want port of router dir300
Maybe you dont understnad what they are actually said.
Below is the picture, maybe you can understand
But I suggest you to call an expert to set up your connection.