Thread: Is there anysoftware to check line attenuation and snr margin

i check my snr and line attenuation values by logging in modem configuration page
http://192.168.1.2/webconfig/status/bb_status.html?110

here is the result please check

and the motive software doesnt configure my modem ,its never proceeds after some process.

here is the information about my modem
Equipment Vendor ZTE
Model No ZXDSL 831AII
Chipset Part No ZXDSL 831AIIV1.0.1i_D18_IN
Chipset Version No E.37.7.37
ADSL Port Enabled
Downstream Line Rate 1907 kbps
Upstream Line Rate 862 kbps
LAN IP Address 92.168.1.2
Default Gateway automatically set
Primary DNS Server not currently set
Secondary DNS Server not currently set
Firmware Version ZXDSL 831AIIV1.0.1i_D18_IN
MAC Address 00:19:C6:8A:B5:FE
System Up Time 00:05:20s

here it says that Default Gateway is automatically set and also the
Primary DNS Server & Secondary DNS Server not currently set.
where to change my dns to new open dns ????

You can change your DNS on

Network connections > Select your connection > Right click - Properties > TCP/IP properties > Change your DNS.

You have given an internal link which will work only in PC. Take a screen shot and upload it in tinypic.

For SNR and Attenuation, check this table,

Originally Posted by meetdilip

You can change your DNS on

Network connections > Select your connection > Right click - Properties > TCP/IP properties > Change your DNS.

You have given an internal link which will work only in PC. Take a screen shot and upload it in tinypic.

For SNR and Attenuation, check this table,

Although i changed it the values are not reflecting in my modem config page
take a look


and what about the software to check snr and line attenuation????
here is my values
Local SNRMargin 36.0 dB
Local Line Attn 28.0 dB

Remote Line Attn 15.0 dB
Remote SNRMargin 8.5 dB

here it shows local and remote which one should i compare??

Local and remote are nothing but upload and download. If you change in TCP/IP, it will not reflect in modem. But it will work.

Originally Posted by meetdilip

Local and remote are nothing but upload and download. If you change in TCP/IP, it will not reflect in modem. But it will work.

@meetdilip thanks for assistance, i gave ur rep for this .because i was confused about this from long back.and you said its upload and download.will you please specify which is for upload and download
for eg:local for download or remote for uplaod(just an example)
i dont know about it

What about the software to check snr and line attenuation????

Local means at your end so, we can consider it as download
Remote means at DSLAM end so, It can be considered as Upload.

I hope, You, are clear now.

I think that there is no such software for showing snr and line attunuation values.