bt.transp_disposition - Determines the kind of outgoing connections from your client. Incoming is not affected. Its value can be 0,1,2 or 3
0: attempts only TCP
1: attempts both TCP and uTP, drop TCP if uTP is successful
2: attempts uTP if supported, TCP otherwise
3: attempts only uTP
In 1.8.2, default was changed to utP only. utp is the protocol that tries to slow down bittorrent when network load is more. It was made so isps won't complain about bittorrent congesting the network.
For this reason some people might say 1.8.1 is better but you can always turn off utp in newer versions. I personally have never seen slower speeds with utp on and mostly nobody cares about it.
That version of utorrent also doesn't support udp. Some say udp is more prone to isp throttling. But bsnl doesn't throttle bitorrent so you dont have to worry about that.
You say you are new to bittorrent so I highly doubt you use any private trackers that restrict certain utorrent builds cause their website hasn't been updated and the ratios might not be updated correctly. the only build that none of the trackers allow is 2.0 cause utorrent had made it in that version so people with slower upload speeds would upload less and more load would be put on those who have higher speeds.
My suggestion is dont worry about the client versions, just use the latest version if you use public trackers and for private trackers just use the latest version that they allow. Like if a tracker allows 1.8.1, 1.8.5, 2.2.1 and 3.0, I would suggest use 3.0 . Just select a proper upload speed when configuring your client and that should be enough.
If you are on 512 kbps, just put total = 2 or 3 (can put even more, cause less upload is needed as overhead for 512kbps)can i download multiple torrents at a time
download = 1.
If you are on a higher speed like 2mbps, use total = 2 or 3 (more is fine but use max 3 so you download is not affected)
and download = 1 or 2 (depending on download speed)
upload speed = put 70% - 80% of total upload speed.
maximum number of connections = use the default after you have put 70 -80% of upload speed in auto configuration wizard. For 512 kbps, you can lower it so you download from less people. Remember, downloading at x kbps from 1 person is better than downloading it from 2 persons at the same rate so overhead is less.



LinkBack URL
About LinkBacks
Reply With Quote