Thread: ITI DNA-A201BEI configuration

I need help to configure my ITI DNA-A201BEI BSNL BB modem in PPPoE mode.

Try this (similar interface)

UTSTAR WA3002-G4 quick reference

Thank you for your response to my thread.
In the ATM PVC configuration, how much will be the PORT value which is given as (0-3)? This option was not there in the links you provided and also please state how much will be the MTU size.

ITI DNA-A201BEI BSNL BB modem

VPI VCI 0 and 35 for BSNL. MTU 1492.
Values are same in all modems.
If menu pages are different , confirm.
http://www.indiabroadband.net/attach...1&d=1314368518

old thread with screenshots
http://www.indiabroadband.net/bsnl-b...tml#post330865 (How to change from PPPoE to bridge mode)

Thank you for your response to my thread.
In the ATM PVC configuration, how much will be the PORT value which is given as (0-3)? This option was not there in the links you provided and also please state how much will be the MTU size.

Did you check the mp.bsnl link in the thread ? It could have helped.

No issues,

Use port entry as zero and MTU as 1492.

Hope it worked. Do update if you are facing any issues.

Thanks now its working nicely. The LAN IPv6 address and Default IPv6 Gateway isnt showing anything, is that normal?

Thanks now its working nicely.

Congrats

The LAN IPv6 address and Default IPv6 Gateway isnt showing anything, is that normal?

Where ?

@meetdilip
please confirm where Port (0-3) is shown in ATMPVC page ?
Value set to 0 ?
Is the model same as Beetel 220BX etc.

Network LAN/ /properties/
New page
Network settings
uncheck IPV6. box Not required )
apply save.
( checking in Ipconfig /all ???)

@ essbebe,

Gave the values as seen in my modem. Using WA3002G4.

WA3002G4.
ATM PVC Port 0-3 :select 0.
Please mention the menu page.
Advanced Options WAN LAN NAT etc
I have Beetel110BXI less WIFImenu.

In the WAN page, after editing the 0/35 entry, I found this option. I didn't remember entering it. May be it is there by default. The option is also mention in the mp.bsnl link, but they have not specified any value to enter.

confirmed range is 0-255. vpi 0 vci 35. for BSNL

Thanks.

oh, nice. ...............

I was talking about this:

Ya, I know. ..................

@meetdilip
For this model the FW could have been upgraded..
If Port 1 to 3 is selected what will happen ???
try and give feedback.
Also referred Chennai link for screen shots for wa3002_g4.
http://www.chennai.bsnl.co.in/BBS/WA...s/image008.jpg

@andy2703
Please post screenshot of Device Info.of DNA A201BEI
speed Ip etc not needed.
one model: DNA A201BE

Ok, will check and update. Unlike the screen shot in the above post, I have this port value entry (as in @andy2703's screen shot).

@meetdilip
OK. verified similar Port 0-3 also appears in
MTNL supplied modem/router DNA a 213.
But what the PORT option will do NO idea!

Here is my device info screenshot:

@andy2703.
Thanks for the feedback.
I think port 0 to 3 (IN WAN Page) has to be selected depending on the
DSlam connection in the Exchange. Not sure. checking up
will update later.
Check your USER CP.

Rep+++ 25 for new info and feedback