Thread: Dlink 802C setup with Netgear 16 port switch

How to setup Dlink 802C with 16 port switch?

I already configure this modem with PPPoE mode & its work fine when i connect to a PC directly but when i connect through switch it's net connect not pass through switch & page can not be display.

In my switch connect 5 nos of PC & IP starts from 192.168.0.2

Please help me.

PPPoE mode ( Userid/PW stored/entered in modem menu page )
Check and enable DHCP .
Give a range say 192.168.1.5 to 192.168.1.20
All systems/desktop laptop Obtain Ip address automatically.
Feedback.

Originally Posted by essbebe

PPPoE mode ( Userid/PW stored/entered in modem menu page )
Check and enable DHCP .
Give a range say 192.168.1.5 to 192.168.1.20
All systems/desktop laptop Obtain Ip address automatically.
Feedback.

I can't change the IP range because some software are configured with this IP address & it's shared all PC. If i change Modem IP how is the procedure?

Switch Model : NETGEAR Pro safe 10/100 16 Port Switch, Model-JFS516.

It not configured automatically, I assigned IP manually & it's starts 192.168.0.2 not 192.168.1.2

PPPoE mode.
Have you entered your USERID/PW in modem WAn page.?
Do you connect to Internet automatically?
Ip addresses no problem.

Originally Posted by essbebe

PPPoE mode.
Have you entered your USERID/PW in modem WAn page.?
Do you connect to Internet automatically?
Ip addresses no problem.

I have already configured the Modem with PPPoE & it's connects automatically & when the modem connect directly with a PC it's works very good.

Lets i discuss broadly:
I have 5 PC & 1 network printer, it's connects each other with a 16 Port switch. The PC's IP address are i)192.168.0.2 ii)192.168.0.3 iii)192.168.0.4 iv)192.168.0.5 v)192.168.0.6 & printer IP 192.168.0.50 which i assigned manually in TCP/IP Properties & turned off windows Firewall & one have them diclared as SERVER & shared the server over my local network.

In that situation i connect the modem directly in the switch, but page can't be display when open a browser.

Is it necessary LAN configuration in Modem ? or Modem's Firewall block the traffic ? or NAT block the traffic ?

My question how i configure the modem ?

Substitute GLB802C for VPN unit.

SmartWizard Discovery is Windows-based software from the Smart Switch CD. You have to install the software on a PC on the same network as the Smart Switch. The putting the CD-ROM in your CD drive should automatically start the installation process. The installation file is setup.exe. Simply double-click the file icon to start installation, and follow the directions. Once Smartwizard Discovery is installed, a shortcut icon appears on the desktop. You can start it by double-clicking the icon any time.