India Broadband

Originally Posted by ozdesi

I was able to set up always on connection with this modem. With this method I do not need to dial the connection every time I boot the PC.

Mind you , this was done on a Desktop with an Ethernet connection to WA3002G4. I am yet to test this with a Wireless Laptop although I have enabled and encrypted WAN. I "think" this should be a multiuser setup.

Here is what I have done.

Go into modem setup from browser (192.168.1.1, admin/admin)

Click Advanced Setup> WAN Setup
Click "Edit" on First Row showing 0/35 under VPI/VCI column.
Uner ATM PVC Configuration
VPI: [0-255]=35
VCI: [1-65535]=35

Enable VLAN Tagging = do not select
Service Category: = UBR without PCR
click next
Select "PPP over Ethernet (PPPoE)" and Encapsulation Mode = "LLC/SNAP-Bridging"
Click Next

Under PPP Username and Password
PPP Username: = <Your Dataonne UserName>
PPP Password: = <Your Dataone Password>
PPPoE Service Name: = Leave this Blank
Authentication Method: = Auto
Do not select anything else on this page.

Enable NAT = yes
Enable Firewall =yes
Enable IGMP Multicast = yes
Enable WAN Service = yes
Service Name =pppoe_0_35_1 (or anything else)
Click next

Now "WAN Setup - Summary" should look like this
VPI / VCI: 0 / 35
Connection Type: PPPoE
Service Name: pppoe_0_35_1
Service Category: UBR
IP Address: Automatically Assigned
Service State: Enabled
NAT: Enabled
Firewall: Enabled
IGMP Multicast: Enabled
Quality Of Service: Disabled

Click "Save".
Click "Save and Reboot" on next page

**Restart your PC and WA3002G4**

Go to "Network Connections"

Select "Local Area Connection" and "1394 Connection" at the same time (hold down control key)
Right click and select "Bridge Connections".
Let windows Create Network Bridge. After few seconds it will shows status as "Connected".

Voila!

Originally Posted by djrudra

i ran a diagnostic in the router page and this is the result i got..

pppoe_0_35_1 Diagnostics

Your modem is capable of testing your DSL connection. The individual tests are listed below. If a test displays a fail status, click "Rerun Diagnostic Tests" at the bottom of this page to make sure the fail status is consistent. If the test continues to fail, click "Help" and follow the troubleshooting procedures.

Test the connection to your local network
Test your ENET(1-4) Connection: PASS
Test your Wireless Connection: PASS

Test the connection to your DSL service provider
Test ADSL Synchronization: PASS
Test ATM OAM F5 segment ping: PASS
Test ATM OAM F5 end-to-end ping: PASS

Test the connection to your Internet service provider
Test PPP server connection: FAIL
Test authentication with ISP: PASS
Test the assigned IP address: FAIL
Ping default gateway: FAIL
Ping primary Domain Name Server: PASS


what is up with the fail??

i am connected to the net, getting down speeds of 30 kbps(normal??? at least that's what i've got from the beginning...)

why and what is failing??

thanks

ananda