Thread: Cannot access 192.168.1.1 on DSL-502T

Hi Friends - I'm new to this forum, so apologies if this has already been resolved. I have an MTNL 2Mbps connection with their D-Link DSL-502T modem. I am on Windows Vista and use IE8.

Till a few days back I could access my router easily using 192.168.1.1. Today it has stopped working. I tried switching the modem on/off and I got access once or twice but now it has completely stopped.

I cleant my browser's cache, temp files, etc. etc. but it didn't work. Couldn't get access on either IE8 or FF.

Would appreciate help. Thanks.

You have not activated your account and hence your posts are going into moderation queue. Please click on the link in the mail you received from the forum admin in your mailbox. Failure to do so will cause all your posts go into moderation.

try setting up static ip like this way Prashanth Speaks-Technology and Life: Internet Works on one PC but not on the Other - WINDOWS

Has your internet stopped working also?

You could try reseting the modem by pressing the RESET button on the back panel. After reseting, the modem will default to factory settings, all settings will be lost and then you can reconfigure the setup again.

@anupamg

1.Start RUN type cmd click ok
New window opens
type ipconfig /all
Post data here.
The Modem/router Ip is listed.

2. In case , you access Internet and can surf
check your IP.
Current IP Check
OPen IE
type it in the address bar.
Do you get a window asking for ID/PW to access modem ?
type it
Feedback.

3. RESETTING the modem to factory settings.
( mentioned above )

4. for settings . Use BSNL VPI/VCI 0 35
http://socrates0.blogspot.com/2006/0...uter-for.html4.
FEEDback.

I had the same problem guys.

I tried to find the solution on google.
I tried everything i found on may forums except resetting router.
But no luck.

Then i replaced my router with other same type of router to see
whether i can open 192.168.1.1

And yes. I was able to open that page.

and then I replaced my router which i was using.
It didnt work with that.

I thought it must be the incoming line causing the problem.

I disconnected my incoming line (Telephone Line) from my ISP (BSNL),
Switch off and switch on,
and tried to open 192.168.1.1.

and it worked.

Try this, it may work for you also.

Raj

Dear Friends,

Few days back my laptop got formatted, since then I am not able to connect to internet. Before that it was working fine.

I installed windows XP with service pack 2 on my system
installed all the drivers etc.

I have MTNS's adcl router WA3002-G1 ,

when I open my internet explorer and try to connect to 192.168.1.1

it does not open up.

I have set my connection setting to automatically detect settings.

Tried pressing reset button.

Please help me to configure my internet connection

Thanks
Neemay