Thread: Configuring UTSTARCOM WA3002G4 WiFi Modem

Originally Posted by essbebe

Enable dhcp 192.168.1.3 to say 192.168.1.10
SAVE reboot.

Where to do this?
SAM or SA3002?

You can enable DHCP in SAM300AX range say 192.168.1.3 to 192.168.1.10

I connected SAM300X. Connected LAN1(SAM) - PC. Then LAN4 of SAM300X to LAN1 of SA3002.
Assigned IP 192.168.1.1 to SAM, DHCP from 192.168.1.3
and 192.168.1.2 for SA3002, DHCP from 192.168.1.4

Is there anything wrong?

It was for the first time that DSL led was blinking for such a long time & when I saw logs, it was showing ADSL link down...

Disable DHCP in WA3002_g4. ( now used as a switch )
If desktop works in LAN mode ( SAM300AX+WA3002-G4)
WIFI can also work.Watch the WLAN light.
more later in the morning.

Originally Posted by essbebe

Disable DHCP in WA3002_g4. ( now used as a switch )
If desktop works in LAN mode ( sam300AX+wa33002G4)
WIFI can also work.Watch the WLAN light.
more later in the morning.

That was wonderful. As soon as I disabled DHCP in WA3002G4, WiFi started working...


Thanks a ton!
But this is a temporary solution, I want only SA3002G4. So our work is not over yet... Just joking... But yes I will be needing your help...

Congratulations
That was wonderful. As soon as I disabled DHCP in WA3002G4, WiFi started working...

check your USERCP

Confirm whether you used "MER" "PPPoE" or" STATIC IP" setting.

Confirm you could access router settings at 192.168.1.2.

2.
I am sorry.All indications, that the ADSL Input ( rj11) to WA3002-g4 is damaged internally, ( The signal IC probably )due to unknown cause/s.
The menu page Summary Statistics/ ADSL will not show SNR/ATTN data.
even though now wifi part is working.

3.
You have saved Approx Rs 1400/= cost of standalone wifi router!!
If you are buying a new one , check WDS/WDM menu available.
( In WA3002_g4 may be available )
http://*******************/index.php?topic=4978.0

rep++ 28 points from me

Originally Posted by essbebe

Congratulations

Thanks!

Originally Posted by essbebe

That was wonderful. As soon as I disabled DHCP in WA3002G4, WiFi started working...

check your USERCP

Confirm whether you used "MER" "PPPoE" or" STATIC IP" setting.

Confirm you could access router settings at 192.168.1.2.

I used PPPoE setting. Used 192.168.1.2 in LAN settings & can access WA3002G4 also at the same time with SAM300X at 192.168.1.1