Thread: D-Link DSL-2520U MTNL Configuration

@mickey - Will not use in future.

@ essbebe - yes SNMP is disabled.

http://www.imgbr.org/images/48687759809271495603.png

Problem Pending : modem access ID/PW fails. RESET again.
Dlink DSL 2520U
If internet is working , wait for one or two days and give feedback, IF
Modem access Id and PW admin and admin. does not work.

Save current modem settings to hard disk.

Change the modem access PW now to password. SAVE reboot.

Try 192.168.1.1/tr69cfg.html

Please Delete Insert mode for screen shot.

Feedback.

Originally Posted by essbebe

@mickey:
shows annoyance /frustration!
RE: my lack of knowledge about modems !!

world order needs to be changed..

@essbebe - here is my tr_069 menu screenshot

http://www.imgbr.org/images/95442278513767230550.png

Thanks for feedback. Appears , my suspicion that the menu page
is hidden is correct. 192.168.1.1/tr69cfg.html
But sometimes this also fails.
( BSNLUt300r2U NAT options !same board) )

Para two:
There is no reason why your Modem access ID and PW should change.

Ensure REBOOT the modem from Management SAVE/REBOOT menu
after changes are made .
Anyway please report problem if it happens again.
Dlink Service Center will/may l suggest some FW ( firmware upgrade ).

Thanks I will ask D-LINK guys for this problem.

After disabling DHCP on my new modem [D-LINK] uTorrent speed comes up/down even wid high seeds but same file with my Old modem Xavi 8821r+ speed on uTorrent is constant even in low seeds.

Is there any problem wid my router?

Compare modem settings in Both XAVI and dlink 2520U.
Portforwarding done ?
check here.Port Forwarding Guides Listed by Manufacturer and Model - PortForward.com select Beetel 220BXI

Further queries on uTorrent please open new thread.

Advanced options:
NAT:
Virtual servers 192.168.1.1/scvrtsrv.cmd?action=view
Port triggering : .............../scprttrg.cmd?action=view
DMZ : ................../scdmz.html

Thanks essbebe, portmapping done and now speed is constant.

thanks for your support

Admin/Mod plz close this thread!