India Broadband Forum

chetak.kansara

Hi,
I got tata indocom wimax broadband 384 Kbps with dynamic IP a week ago. They have configured the router in bridge mode as I can see from the config page. I'm trying to configure my Trendnet Wireless router, Model NO TEW 432-BRP. But I'm not able to connect to the internet.
I connect the Ethernet cable to the Bridge and the Router and The Data cable from router to my laptop. The config process gets stuck after that while trying to check the internet connection and it says you dont have internet connection. So it shows no login page.

Here are the steps I follow to connect.

- Connect to internet normally
- Insert router CD and start config
- Select Add Router
- Detach power cable from Bridge (provided by tata)
- Take out Data In cable from bridge and insert into 1 of the 4 yellow ports on the router.
- Connect ethernet cable in DATA IN slot of the bridge and the WAN slot of the router.
- Connect power to modem and router.
- proceed with connection wizard
-The wizard configures the router and restarts the network
- Then I provide ISP supplied username/pwd in the wizard.
- Then it checks for internet connection and gets stuck.

Please help me out...

ashraf_zaidi

follow these steps and see if the problem persist

1) go to networ and sharing centre, select manage network connection
2)double click LAN
3)go to IPv4 click on properties, select "obtain IP address automatically, and "Obtain DNS server address automatically"
4)now connect the cable from port 1 to lan of yr computer
5)open the web page of the router, change the ip address under basic setting to 192.168.1.2, this is very imprtant as the Subscriber station also has the IP address as 192.168.1.1
6)clone yr pc mac
7)take out all the wires, insert the cable comming from the POE to yr system again, check if u can get connected, once done , insert the CD provided by the router, all will go smoothly
8)enjoy the wifi experinace.

Thanks me once u are done!!!!

ruchirsaurabh

Hi Chetak,

Were you able to connect with the Trendnet router?? I too seem to have the same problem.